Home › Code lookup › P260A
Powertrain code · Engine

P260A PTO Control Circuit/Open

How urgent? Book a check when convenient

What it means

The computer is watching the PTO control circuit and sees what looks like a broken or disconnected circuit. The power take-off lets a work truck engine drive equipment like a pump or hoist.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the PTO control circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Power take-off may not engage

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the PTO control solenoid or relay
  • CommonBroken or chafed wire in the PTO control circuit
  • CommonFailed PTO control solenoid or relay
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the PTO control solenoid or relay.

Common questions

What does P260A mean?

The computer is watching the PTO control circuit and sees what looks like a broken or disconnected circuit. The power take-off lets a work truck engine drive equipment like a pump or hoist.

Can I drive with code P260A?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P260A?

Common possibilities to test include: unplugged, loose or corroded connector at the pto control solenoid or relay; broken or chafed wire in the pto control circuit; failed pto control solenoid or relay; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.