Home › Code lookup › P260C
Powertrain code · Engine

P260C PTO Control Circuit High

How urgent? Book a check when convenient

What it means

The computer is watching the PTO control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The power take-off lets a work truck engine drive equipment like a pump or hoist.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the PTO control circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Power take-off may not engage

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the PTO control solenoid or relay shorted to voltage or the part open inside
  • CommonFailed PTO control solenoid or relay
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the PTO control solenoid or relay.

Common questions

What does P260C mean?

The computer is watching the PTO control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The power take-off lets a work truck engine drive equipment like a pump or hoist.

Can I drive with code P260C?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P260C?

Common possibilities to test include: control wire to the pto control solenoid or relay shorted to voltage or the part open inside; failed pto control solenoid or relay; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.