Home › Code lookup › P2610
Powertrain code · Computer

P2610 ECM/PCM Internal Engine Off Timer Performance

How urgent? Book a check when convenient

What it means

The engine computer keeps a timer that counts how long the engine has been off. That timer does not agree with other clocks in the car, so some self-tests cannot run.

Can I keep driving?

Usually yes; this rarely affects how the car drives. It mainly affects emissions readiness. Get it checked when convenient, especially before an inspection.

What to test before replacing parts

Check battery condition, computer power and ground circuits, and look for software updates or service bulletins before replacing the engine computer.

  1. Test the battery and clean the terminals
  2. Check for a software update or service bulletin for the engine computer
  3. Clear the code and see if it returns after a few drive cycles

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May not pass an emissions readiness check

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWeak or recently disconnected battery
  • CommonEngine computer software that needs an update
  • CommonPoor power or ground connection at the engine computer
  • PossibleFault in another module that shares time data
  • PossibleInternal engine computer fault

Typical repair once the cause is confirmed

Often fixed by a software update or by correcting a battery or power problem; the computer is rarely replaced.

Repair costInsufficient verified pricing for this vehicle and repair
Engine computer software update. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P2610 mean?

The engine computer keeps a timer that counts how long the engine has been off. That timer does not agree with other clocks in the car, so some self-tests cannot run.

Can I drive with code P2610?

Usually yes; this rarely affects how the car drives. It mainly affects emissions readiness. Get it checked when convenient, especially before an inspection.

What causes P2610?

Common possibilities to test include: weak or recently disconnected battery; engine computer software that needs an update; poor power or ground connection at the engine computer; fault in another module that shares time data. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.