P2617 Crankshaft Position Signal Output Circuit/Open
What it means
The computer is watching the crankshaft position signal output circuit and sees what looks like a broken or disconnected circuit. The engine computer passes the engine speed signal on to another module, such as the transmission computer.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the crankshaft position signal output circuit, checking for damage, corrosion or a loose fit
- Check power, ground and signal with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine light on
- Possible shifting, idle or gauge problems on systems that use the signal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWiring or connector fault between the engine computer and the module receiving the signal
- CommonCorroded or loose connector
- PossibleFault in the receiving module
- PossibleEngine computer output fault
Typical repair once the cause is confirmed
Repair the wiring or connector; module replacement is only needed if the circuit tests good.
Common questions
What does P2617 mean?
The computer is watching the crankshaft position signal output circuit and sees what looks like a broken or disconnected circuit. The engine computer passes the engine speed signal on to another module, such as the transmission computer.
Can I drive with code P2617?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2617?
Common possibilities to test include: wiring or connector fault between the engine computer and the module receiving the signal; corroded or loose connector; fault in the receiving module; engine computer output fault. A shop should confirm the cause before replacing parts.