P2618 Crankshaft Position Signal Output Circuit Low
What it means
The computer is watching the crankshaft position signal output circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The engine computer passes the engine speed signal on to another module, such as the transmission computer.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring in the crankshaft position signal output circuit for rubbed-through insulation touching metal
- Check the wiring for a short to ground with a meter
- Clear the code and see if it returns right away
Signs you may notice
- Check engine light on
- Possible shifting, idle or gauge problems on systems that use the signal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWiring or connector fault between the engine computer and the module receiving the signal
- CommonCorroded or loose connector
- PossibleFault in the receiving module
- PossibleEngine computer output fault
Typical repair once the cause is confirmed
Repair the wiring or connector; module replacement is only needed if the circuit tests good.
Common questions
What does P2618 mean?
The computer is watching the crankshaft position signal output circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The engine computer passes the engine speed signal on to another module, such as the transmission computer.
Can I drive with code P2618?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2618?
Common possibilities to test include: wiring or connector fault between the engine computer and the module receiving the signal; corroded or loose connector; fault in the receiving module; engine computer output fault. A shop should confirm the cause before replacing parts.