Home › Code lookup › P2619
Powertrain code · Computer

P2619 Crankshaft Position Signal Output Circuit High

How urgent? Book a check when convenient

What it means

The computer is watching the crankshaft position signal output circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The engine computer passes the engine speed signal on to another module, such as the transmission computer.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the crankshaft position signal output circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Possible shifting, idle or gauge problems on systems that use the signal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWiring or connector fault between the engine computer and the module receiving the signal
  • CommonCorroded or loose connector
  • PossibleFault in the receiving module
  • PossibleEngine computer output fault

Typical repair once the cause is confirmed

Repair the wiring or connector; module replacement is only needed if the circuit tests good.

Common questions

What does P2619 mean?

The computer is watching the crankshaft position signal output circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The engine computer passes the engine speed signal on to another module, such as the transmission computer.

Can I drive with code P2619?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2619?

Common possibilities to test include: wiring or connector fault between the engine computer and the module receiving the signal; corroded or loose connector; fault in the receiving module; engine computer output fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.