Home › Code lookup › P261C
Powertrain code · Cooling

P261C Coolant Pump "B" Control Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer is watching the coolant pump "B" control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Some engines use an electric pump to move coolant through the engine, turbo or heater.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Watch the temperature gauge and pull over if it climbs
  2. Inspect the wiring in the coolant pump "B" control circuit for rubbed-through insulation touching metal
  3. Check the wiring for a short to ground with a meter
  4. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Engine may run hot
  • Heater may blow cooler air

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the electric coolant pump shorted to ground
  • CommonFailed electric coolant pump
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the electric coolant pump.

Walk through it step by step: Engine overheating →

Common questions

What does P261C mean?

The computer is watching the coolant pump "B" control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Some engines use an electric pump to move coolant through the engine, turbo or heater.

Can I drive with code P261C?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P261C?

Common possibilities to test include: control wire to the electric coolant pump shorted to ground; failed electric coolant pump; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.