P261D Coolant Pump "B" Control Circuit High
What it means
The computer is watching the coolant pump "B" control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Some engines use an electric pump to move coolant through the engine, turbo or heater.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Watch the temperature gauge and pull over if it climbs
- Inspect the wiring and ground connection for the coolant pump "B" control circuit
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- Engine may run hot
- Heater may blow cooler air
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonControl wire to the electric coolant pump shorted to voltage or the part open inside
- CommonFailed electric coolant pump
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the open ground or shorted wire; if the wiring is fine, replace the electric coolant pump.
Common questions
What does P261D mean?
The computer is watching the coolant pump "B" control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Some engines use an electric pump to move coolant through the engine, turbo or heater.
Can I drive with code P261D?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P261D?
Common possibilities to test include: control wire to the electric coolant pump shorted to voltage or the part open inside; failed electric coolant pump; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.