Home › Code lookup › P2621
Powertrain code · Computer

P2621 Throttle Position Output Circuit Low

How urgent? Book a check when convenient

What it means

The computer is watching the throttle position output circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The engine computer shares the throttle position with other modules over this line.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the throttle position output circuit for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Possible shifting, idle or gauge problems on systems that use the signal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWiring or connector fault between the engine computer and the module receiving the signal
  • CommonCorroded or loose connector
  • PossibleFault in the receiving module
  • PossibleEngine computer output fault

Typical repair once the cause is confirmed

Repair the wiring or connector; module replacement is only needed if the circuit tests good.

Common questions

What does P2621 mean?

The computer is watching the throttle position output circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. The engine computer shares the throttle position with other modules over this line.

Can I drive with code P2621?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2621?

Common possibilities to test include: wiring or connector fault between the engine computer and the module receiving the signal; corroded or loose connector; fault in the receiving module; engine computer output fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.