P2623 Injector Control Pressure Regulator Circuit/Open
What it means
The computer is watching the injection control pressure regulator circuit and sees what looks like a broken or disconnected circuit. On some diesels this valve sets the high oil pressure used to fire the fuel injectors.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the injection control pressure regulator circuit, checking for damage, corrosion or a loose fit
- Check power, ground and resistance of the part with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine light on
- Hard starting or no start
- Loss of power
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonUnplugged, loose or corroded connector at the injection control pressure regulator (IPR) valve
- CommonBroken or chafed wire in the injection control pressure regulator circuit
- CommonFailed injection control pressure regulator (IPR) valve
- PossibleBlown fuse or failed relay feeding the circuit
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector if it is damaged; otherwise replace the injection control pressure regulator (IPR) valve.
Common questions
What does P2623 mean?
The computer is watching the injection control pressure regulator circuit and sees what looks like a broken or disconnected circuit. On some diesels this valve sets the high oil pressure used to fire the fuel injectors.
Can I drive with code P2623?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2623?
Common possibilities to test include: unplugged, loose or corroded connector at the injection control pressure regulator (ipr) valve; broken or chafed wire in the injection control pressure regulator circuit; failed injection control pressure regulator (ipr) valve; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.