P2624 Injector Control Pressure Regulator Circuit Low
What it means
The computer is watching the injection control pressure regulator circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. On some diesels this valve sets the high oil pressure used to fire the fuel injectors.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring in the injection control pressure regulator circuit for rubbed-through insulation touching metal
- Check the wiring for a short to ground with a meter
- Clear the code and see if it returns right away
Signs you may notice
- Check engine light on
- Hard starting or no start
- Loss of power
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonControl wire to the injection control pressure regulator (IPR) valve shorted to ground
- CommonFailed injection control pressure regulator (IPR) valve
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Fix any shorted wiring first; if the wiring tests good, replace the injection control pressure regulator (IPR) valve.
Common questions
What does P2624 mean?
The computer is watching the injection control pressure regulator circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. On some diesels this valve sets the high oil pressure used to fire the fuel injectors.
Can I drive with code P2624?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2624?
Common possibilities to test include: control wire to the injection control pressure regulator (ipr) valve shorted to ground; failed injection control pressure regulator (ipr) valve; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.