Home › Code lookup › P2626
Powertrain code · Emissions

P2626 O2 Sensor Pumping Current Trim Circuit/Open (Bank 1 Sensor 1)

How urgent? Book a check when convenient

What it means

The computer is watching the O2 sensor pumping current trim circuit (bank 1 sensor 1) and sees what looks like a broken or disconnected circuit. This is a calibration circuit inside the front wide-range (air-fuel ratio) oxygen sensor.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the O2 sensor pumping current trim circuit (bank 1 sensor 1), checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Possible rough running or lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the front wide-range oxygen sensor
  • CommonBroken or chafed wire in the O2 sensor pumping current trim circuit (bank 1 sensor 1)
  • CommonFailed front wide-range oxygen sensor
  • PossibleMissing reference voltage or ground from the computer
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the front wide-range oxygen sensor.

Walk through it step by step: Gas mileage suddenly worse →

Common questions

What does P2626 mean?

The computer is watching the O2 sensor pumping current trim circuit (bank 1 sensor 1) and sees what looks like a broken or disconnected circuit. This is a calibration circuit inside the front wide-range (air-fuel ratio) oxygen sensor.

Can I drive with code P2626?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2626?

Common possibilities to test include: unplugged, loose or corroded connector at the front wide-range oxygen sensor; broken or chafed wire in the o2 sensor pumping current trim circuit (bank 1 sensor 1); failed front wide-range oxygen sensor; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.