Home › Code lookup › P2627
Powertrain code · Emissions

P2627 O2 Sensor Pumping Current Trim Circuit Low (Bank 1 Sensor 1)

How urgent? Book a check when convenient

What it means

The computer is watching the O2 sensor pumping current trim circuit (bank 1 sensor 1) and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This is a calibration circuit inside the front wide-range (air-fuel ratio) oxygen sensor.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the O2 sensor pumping current trim circuit (bank 1 sensor 1) for rubbed-through insulation touching metal
  2. Unplug the front wide-range oxygen sensor and see if the reading changes
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Possible rough running or lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire in the O2 sensor pumping current trim circuit (bank 1 sensor 1) shorted to ground or open
  • CommonFailed front wide-range oxygen sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the front wide-range oxygen sensor.

Walk through it step by step: Gas mileage suddenly worse →

Common questions

What does P2627 mean?

The computer is watching the O2 sensor pumping current trim circuit (bank 1 sensor 1) and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This is a calibration circuit inside the front wide-range (air-fuel ratio) oxygen sensor.

Can I drive with code P2627?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2627?

Common possibilities to test include: signal wire in the o2 sensor pumping current trim circuit (bank 1 sensor 1) shorted to ground or open; failed front wide-range oxygen sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.