P2629 O2 Sensor Pumping Current Trim Circuit/Open (Bank 2 Sensor 1)
What it means
The computer is watching the O2 sensor pumping current trim circuit (bank 2 sensor 1) and sees what looks like a broken or disconnected circuit. This is a calibration circuit inside the front wide-range (air-fuel ratio) oxygen sensor.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the O2 sensor pumping current trim circuit (bank 2 sensor 1), checking for damage, corrosion or a loose fit
- Check power, ground and signal with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine light on
- Possible rough running or lower fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonUnplugged, loose or corroded connector at the front wide-range oxygen sensor
- CommonBroken or chafed wire in the O2 sensor pumping current trim circuit (bank 2 sensor 1)
- CommonFailed front wide-range oxygen sensor
- PossibleMissing reference voltage or ground from the computer
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector if it is damaged; otherwise replace the front wide-range oxygen sensor.
Common questions
What does P2629 mean?
The computer is watching the O2 sensor pumping current trim circuit (bank 2 sensor 1) and sees what looks like a broken or disconnected circuit. This is a calibration circuit inside the front wide-range (air-fuel ratio) oxygen sensor.
Can I drive with code P2629?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2629?
Common possibilities to test include: unplugged, loose or corroded connector at the front wide-range oxygen sensor; broken or chafed wire in the o2 sensor pumping current trim circuit (bank 2 sensor 1); failed front wide-range oxygen sensor; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.