P2631 O2 Sensor Pumping Current Trim Circuit High (Bank 2 Sensor 1)
What it means
The computer is watching the O2 sensor pumping current trim circuit (bank 2 sensor 1) and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This is a calibration circuit inside the front wide-range (air-fuel ratio) oxygen sensor.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the O2 sensor pumping current trim circuit (bank 2 sensor 1)
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- Possible rough running or lower fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal wire shorted to voltage or a broken ground wire
- CommonFailed front wide-range oxygen sensor
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the open ground or shorted wire; if the wiring is fine, replace the front wide-range oxygen sensor.
Common questions
What does P2631 mean?
The computer is watching the O2 sensor pumping current trim circuit (bank 2 sensor 1) and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This is a calibration circuit inside the front wide-range (air-fuel ratio) oxygen sensor.
Can I drive with code P2631?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2631?
Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed front wide-range oxygen sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.