Home › Code lookup › P2632
Powertrain code · Fuel and air

P2632 Fuel Pump "B" Control Circuit/Open

How urgent? Get it checked in the next few days

What it means

The computer is watching the fuel pump "B" control circuit and sees what looks like a broken or disconnected circuit. Some vehicles have a second fuel pump, or a pump run by its own control module.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the fuel pump "B" control circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Hard starting or stalling
  • Loss of power under load

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the secondary fuel pump or its driver module
  • CommonBroken or chafed wire in the fuel pump "B" control circuit
  • CommonFailed secondary fuel pump or its driver module
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the secondary fuel pump or its driver module.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P2632 mean?

The computer is watching the fuel pump "B" control circuit and sees what looks like a broken or disconnected circuit. Some vehicles have a second fuel pump, or a pump run by its own control module.

Can I drive with code P2632?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2632?

Common possibilities to test include: unplugged, loose or corroded connector at the secondary fuel pump or its driver module; broken or chafed wire in the fuel pump "b" control circuit; failed secondary fuel pump or its driver module; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.