Home › Code lookup › P2633
Powertrain code · Fuel and air

P2633 Fuel Pump "B" Control Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer is watching the fuel pump "B" control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Some vehicles have a second fuel pump, or a pump run by its own control module.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the fuel pump "B" control circuit for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Hard starting or stalling
  • Loss of power under load

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the secondary fuel pump or its driver module shorted to ground
  • CommonFailed secondary fuel pump or its driver module
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the secondary fuel pump or its driver module.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P2633 mean?

The computer is watching the fuel pump "B" control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Some vehicles have a second fuel pump, or a pump run by its own control module.

Can I drive with code P2633?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2633?

Common possibilities to test include: control wire to the secondary fuel pump or its driver module shorted to ground; failed secondary fuel pump or its driver module; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.