P2642 Torque Management Feedback Signal "B" Range/Performance
What it means
The computer is watching the torque management feedback signal and is getting a signal that does not make sense for current conditions. The engine computer uses this signal to report back to other modules (often the transmission) how much torque it is making.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check for other codes that point to the underlying problem
- Compare the torque management feedback signal reading with expected values in live data
- Inspect the wiring and connector
Signs you may notice
- Check engine light on
- Harsh or firm shifts
- Reduced power mode possible
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWiring or connector fault between the engine and transmission computers
- CommonNetwork communication problem between modules
- PossibleModule software that needs an update
- PossibleEngine or transmission computer fault
Typical repair once the cause is confirmed
Repair the wiring or network fault, or update the module software as the maker directs.
Common questions
What does P2642 mean?
The computer is watching the torque management feedback signal and is getting a signal that does not make sense for current conditions. The engine computer uses this signal to report back to other modules (often the transmission) how much torque it is making.
Can I drive with code P2642?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2642?
Common possibilities to test include: wiring or connector fault between the engine and transmission computers; network communication problem between modules; module software that needs an update; engine or transmission computer fault. A shop should confirm the cause before replacing parts.