P2644 Torque Management Feedback Signal "B" High
What it means
The computer is watching the torque management feedback signal and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The engine computer uses this signal to report back to other modules (often the transmission) how much torque it is making.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the torque management feedback signal
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- Harsh or firm shifts
- Reduced power mode possible
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWiring or connector fault between the engine and transmission computers
- CommonNetwork communication problem between modules
- PossibleModule software that needs an update
- PossibleEngine or transmission computer fault
Typical repair once the cause is confirmed
Repair the wiring or network fault, or update the module software as the maker directs.
Common questions
What does P2644 mean?
The computer is watching the torque management feedback signal and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. The engine computer uses this signal to report back to other modules (often the transmission) how much torque it is making.
Can I drive with code P2644?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2644?
Common possibilities to test include: wiring or connector fault between the engine and transmission computers; network communication problem between modules; module software that needs an update; engine or transmission computer fault. A shop should confirm the cause before replacing parts.