Home › Code lookup › P2647
Powertrain code · Engine

P2647 "A" Rocker Arm Actuator System Stuck On (Bank 1)

How urgent? Get it checked in the next few days

What it means

The variable valve lift system (like Honda VTEC) seems to stay switched on when it should be off.

Can I keep driving?

Usually drivable with care while you get it checked soon; idle may be rough. Check the oil level first. If the oil pressure light comes on, or there's loud ticking, knocking or misfiring, stop driving and get it checked.

What to test before replacing parts

Check oil level and condition, test oil pressure, the rocker actuator solenoid and its pressure switch or wiring, and check for a stuck rocker before replacing parts.

  1. Check the oil level and condition
  2. Watch the oil pressure switch reading with the engine idling
  3. Unplug the solenoid and see if the switch reading changes

Signs you may notice

  • Check engine light on
  • Rough or uneven idle
  • Possible hesitation at low speed
  • Lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty rocker arm oil pressure switch
  • CommonSticking rocker arm oil control solenoid
  • CommonDirty or sludgy engine oil
  • CommonWrong oil thickness
  • PossibleWiring short in the pressure switch circuit

Typical repair once the cause is confirmed

Most often a new oil pressure switch or solenoid, plus an oil change if the oil is dirty.

Repair costInsufficient verified pricing for this vehicle and repair
Replace VTEC oil pressure switch or solenoid. Prepare an itemized shop request.

Where it shows up

  • Seen on Honda and Acura engines with VTEC

Known on these vehicles

Walk through it step by step: Rough idle or shaking when stopped →

Common questions

What does P2647 mean?

The variable valve lift system (like Honda VTEC) seems to stay switched on when it should be off.

Can I drive with code P2647?

Usually drivable with care while you get it checked soon; idle may be rough. Check the oil level first. If the oil pressure light comes on, or there's loud ticking, knocking or misfiring, stop driving and get it checked.

What causes P2647?

Common possibilities to test include: faulty rocker arm oil pressure switch; sticking rocker arm oil control solenoid; dirty or sludgy engine oil; wrong oil thickness. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.