P264B "A" Rocker Arm Actuator Position Sensor Circuit Range/Performance (Bank 1)
What it means
The computer is watching the "A" rocker arm position sensor (bank 1) and is getting a signal that does not make sense for current conditions. This sensor tells the computer which valve lift mode the rocker arms are actually in.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check for other codes that point to the underlying problem
- Compare the "A" rocker arm position sensor (bank 1) reading with expected values in live data
- Inspect the wiring and connector
Signs you may notice
- Check engine light on
- Variable valve lift may be disabled
- Possible loss of power at higher rpm
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing or sticking rocker arm actuator position sensor
- CommonA real problem in the system the part works with
- PossibleWiring or connector with high resistance
- PossibleComputer software that needs an update
Typical repair once the cause is confirmed
Find out whether the rocker arm actuator position sensor itself or the system it works with is at fault, then repair or replace as needed.
Common questions
What does P264B mean?
The computer is watching the "A" rocker arm position sensor (bank 1) and is getting a signal that does not make sense for current conditions. This sensor tells the computer which valve lift mode the rocker arms are actually in.
Can I drive with code P264B?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P264B?
Common possibilities to test include: failing or sticking rocker arm actuator position sensor; a real problem in the system the part works with; wiring or connector with high resistance; computer software that needs an update. A shop should confirm the cause before replacing parts.