Home › Code lookup › P264C
Powertrain code · Engine

P264C "A" Rocker Arm Actuator Position Sensor Circuit Low (Bank 1)

How urgent? Book a check when convenient

What it means

The computer is watching the "A" rocker arm position sensor (bank 1) and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This sensor tells the computer which valve lift mode the rocker arms are actually in.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the "A" rocker arm position sensor (bank 1) for rubbed-through insulation touching metal
  2. Unplug the rocker arm actuator position sensor and see if the reading changes
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Variable valve lift may be disabled
  • Possible loss of power at higher rpm

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire in the "A" rocker arm position sensor (bank 1) shorted to ground or open
  • CommonFailed rocker arm actuator position sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the rocker arm actuator position sensor.

Walk through it step by step: Check engine light on →

Common questions

What does P264C mean?

The computer is watching the "A" rocker arm position sensor (bank 1) and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This sensor tells the computer which valve lift mode the rocker arms are actually in.

Can I drive with code P264C?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P264C?

Common possibilities to test include: signal wire in the "a" rocker arm position sensor (bank 1) shorted to ground or open; failed rocker arm actuator position sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.