P2659 "A" Rocker Arm Actuator Control Circuit High (Bank 2)
What it means
The computer is watching the "A" rocker arm actuator control circuit (bank 2) and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This oil-operated part switches the valves between low and high lift, like Honda VTEC.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the "A" rocker arm actuator control circuit (bank 2)
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- Loss of power, especially at higher rpm
- Rough idle or hesitation in some cases
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonControl wire to the rocker arm oil control solenoid shorted to voltage or the part open inside
- CommonFailed rocker arm oil control solenoid
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the open ground or shorted wire; if the wiring is fine, replace the rocker arm oil control solenoid.
Common questions
What does P2659 mean?
The computer is watching the "A" rocker arm actuator control circuit (bank 2) and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This oil-operated part switches the valves between low and high lift, like Honda VTEC.
Can I drive with code P2659?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2659?
Common possibilities to test include: control wire to the rocker arm oil control solenoid shorted to voltage or the part open inside; failed rocker arm oil control solenoid; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.