P265C "B" Rocker Arm Actuator Position Sensor Circuit Low (Bank 1)
What it means
The computer is watching the "B" rocker arm position sensor (bank 1) and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This sensor tells the computer which valve lift mode the rocker arms are actually in.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring in the "B" rocker arm position sensor (bank 1) for rubbed-through insulation touching metal
- Unplug the rocker arm actuator position sensor and see if the reading changes
- Clear the code and see if it returns right away
Signs you may notice
- Check engine light on
- Variable valve lift may be disabled
- Possible loss of power at higher rpm
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal wire in the "B" rocker arm position sensor (bank 1) shorted to ground or open
- CommonFailed rocker arm actuator position sensor
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Fix any shorted wiring first; if the wiring tests good, replace the rocker arm actuator position sensor.
Common questions
What does P265C mean?
The computer is watching the "B" rocker arm position sensor (bank 1) and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This sensor tells the computer which valve lift mode the rocker arms are actually in.
Can I drive with code P265C?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P265C?
Common possibilities to test include: signal wire in the "b" rocker arm position sensor (bank 1) shorted to ground or open; failed rocker arm actuator position sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.