Home › Code lookup › P265D
Powertrain code · Engine

P265D "B" Rocker Arm Actuator Position Sensor Circuit High (Bank 1)

How urgent? Book a check when convenient

What it means

The computer is watching the "B" rocker arm position sensor (bank 1) and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor tells the computer which valve lift mode the rocker arms are actually in.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the "B" rocker arm position sensor (bank 1)
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Variable valve lift may be disabled
  • Possible loss of power at higher rpm

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire shorted to voltage or a broken ground wire
  • CommonFailed rocker arm actuator position sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the rocker arm actuator position sensor.

Walk through it step by step: Check engine light on →

Common questions

What does P265D mean?

The computer is watching the "B" rocker arm position sensor (bank 1) and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor tells the computer which valve lift mode the rocker arms are actually in.

Can I drive with code P265D?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P265D?

Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed rocker arm actuator position sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.