Home › Code lookup › P2660
Powertrain code · Engine

P2660 "B" Rocker Arm Actuator Control Circuit/Open (Bank 2)

How urgent? Get it checked in the next few days

What it means

The computer is watching the "B" rocker arm actuator control circuit (bank 2) and sees what looks like a broken or disconnected circuit. This oil-operated part switches the valves between low and high lift, like Honda VTEC.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the "B" rocker arm actuator control circuit (bank 2), checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Loss of power, especially at higher rpm
  • Rough idle or hesitation in some cases

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the rocker arm oil control solenoid
  • CommonBroken or chafed wire in the "B" rocker arm actuator control circuit (bank 2)
  • CommonFailed rocker arm oil control solenoid
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the rocker arm oil control solenoid.

Walk through it step by step: Check engine light on →

Common questions

What does P2660 mean?

The computer is watching the "B" rocker arm actuator control circuit (bank 2) and sees what looks like a broken or disconnected circuit. This oil-operated part switches the valves between low and high lift, like Honda VTEC.

Can I drive with code P2660?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2660?

Common possibilities to test include: unplugged, loose or corroded connector at the rocker arm oil control solenoid; broken or chafed wire in the "b" rocker arm actuator control circuit (bank 2); failed rocker arm oil control solenoid; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.