Home › Code lookup › P2662
Powertrain code · Engine

P2662 "B" Rocker Arm Actuator System Stuck On (Bank 2)

How urgent? Get it checked in the next few days

What it means

The computer thinks the "B" rocker arm actuator (bank 2) is stuck on. This oil-operated part switches the valves between low and high lift, like Honda VTEC.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and condition first
  2. Inspect the screen or filter at the rocker solenoid for debris
  3. Command the solenoid with a scan tool and check the oil pressure switch reading

Signs you may notice

  • Check engine light on
  • Loss of power, especially at higher rpm
  • Rough idle or hesitation in some cases

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonEngine oil low, dirty or the wrong thickness
  • CommonClogged oil screen or filter at the rocker arm solenoid
  • CommonSticking rocker arm oil control solenoid
  • PossibleFaulty oil pressure switch for the rocker system
  • PossibleWorn or sticking rocker arm locking pins

Typical repair once the cause is confirmed

Often fixed with an oil change to the right oil plus a cleaned screen; otherwise replace the solenoid or pressure switch.

Walk through it step by step: Check engine light on →

Common questions

What does P2662 mean?

The computer thinks the "B" rocker arm actuator (bank 2) is stuck on. This oil-operated part switches the valves between low and high lift, like Honda VTEC.

Can I drive with code P2662?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2662?

Common possibilities to test include: engine oil low, dirty or the wrong thickness; clogged oil screen or filter at the rocker arm solenoid; sticking rocker arm oil control solenoid; faulty oil pressure switch for the rocker system. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.