Home › Code lookup › P2663
Powertrain code · Engine

P2663 "B" Rocker Arm Actuator Control Circuit Low (Bank 2)

How urgent? Get it checked in the next few days

What it means

The computer is watching the "B" rocker arm actuator control circuit (bank 2) and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This oil-operated part switches the valves between low and high lift, like Honda VTEC.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the "B" rocker arm actuator control circuit (bank 2) for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Loss of power, especially at higher rpm
  • Rough idle or hesitation in some cases

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the rocker arm oil control solenoid shorted to ground
  • CommonFailed rocker arm oil control solenoid
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the rocker arm oil control solenoid.

Walk through it step by step: Check engine light on →

Common questions

What does P2663 mean?

The computer is watching the "B" rocker arm actuator control circuit (bank 2) and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This oil-operated part switches the valves between low and high lift, like Honda VTEC.

Can I drive with code P2663?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2663?

Common possibilities to test include: control wire to the rocker arm oil control solenoid shorted to ground; failed rocker arm oil control solenoid; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.