Home › Code lookup › P2667
Powertrain code · Fuel and air

P2667 Fuel Shutoff Valve "B" Control Circuit High

How urgent? Get it checked in the next few days

What it means

The computer is watching the fuel shutoff valve "B" control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This valve can stop the flow of fuel, for example on diesel or dual-fuel systems.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the fuel shutoff valve "B" control circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Engine may not start or may stall

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the fuel shutoff valve shorted to voltage or the part open inside
  • CommonFailed fuel shutoff valve
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the fuel shutoff valve.

Walk through it step by step: Car won't start →

Common questions

What does P2667 mean?

The computer is watching the fuel shutoff valve "B" control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This valve can stop the flow of fuel, for example on diesel or dual-fuel systems.

Can I drive with code P2667?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2667?

Common possibilities to test include: control wire to the fuel shutoff valve shorted to voltage or the part open inside; failed fuel shutoff valve; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.