Home › Code lookup › P266A
Powertrain code · Engine

P266A "A" Rocker Arm Actuator Position Sensor Circuit (Bank 2)

How urgent? Book a check when convenient

What it means

The computer is watching the "A" rocker arm position sensor (bank 2) and has spotted an electrical fault. This sensor tells the computer which valve lift mode the rocker arms are actually in.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the "A" rocker arm position sensor (bank 2), checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Variable valve lift may be disabled
  • Possible loss of power at higher rpm

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the rocker arm actuator position sensor
  • CommonBroken or chafed wire in the "A" rocker arm position sensor (bank 2) circuit
  • CommonFailed rocker arm actuator position sensor
  • PossibleMissing reference voltage or ground from the computer
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the rocker arm actuator position sensor.

Walk through it step by step: Check engine light on →

Common questions

What does P266A mean?

The computer is watching the "A" rocker arm position sensor (bank 2) and has spotted an electrical fault. This sensor tells the computer which valve lift mode the rocker arms are actually in.

Can I drive with code P266A?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P266A?

Common possibilities to test include: unplugged, loose or corroded connector at the rocker arm actuator position sensor; broken or chafed wire in the "a" rocker arm position sensor (bank 2) circuit; failed rocker arm actuator position sensor; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.