P266D "A" Rocker Arm Actuator Position Sensor Circuit High (Bank 2)
What it means
The computer is watching the "A" rocker arm position sensor (bank 2) and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor tells the computer which valve lift mode the rocker arms are actually in.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the "A" rocker arm position sensor (bank 2)
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- Variable valve lift may be disabled
- Possible loss of power at higher rpm
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal wire shorted to voltage or a broken ground wire
- CommonFailed rocker arm actuator position sensor
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the open ground or shorted wire; if the wiring is fine, replace the rocker arm actuator position sensor.
Common questions
What does P266D mean?
The computer is watching the "A" rocker arm position sensor (bank 2) and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor tells the computer which valve lift mode the rocker arms are actually in.
Can I drive with code P266D?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P266D?
Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed rocker arm actuator position sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.