P2670 Actuator Supply Voltage "B" Circuit Low
What it means
The computer is watching the actuator supply voltage "B" circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This is a shared power feed the computer uses to run several actuators, such as solenoids and valves.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring in the actuator supply voltage "B" circuit for rubbed-through insulation touching metal
- Check the wiring for a short to ground with a meter
- Clear the code and see if it returns right away
Signs you may notice
- Check engine light on
- Several systems may stop working at once
- Reduced power or limp mode possible
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonA shorted actuator pulling the supply voltage down
- CommonBlown fuse or failed relay in the supply circuit
- CommonWiring short or open in the supply circuit
- PossibleEngine computer fault (rare)
Typical repair once the cause is confirmed
Find the shorted actuator or wire on the shared supply and repair it, then replace any blown fuse.
Common questions
What does P2670 mean?
The computer is watching the actuator supply voltage "B" circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This is a shared power feed the computer uses to run several actuators, such as solenoids and valves.
Can I drive with code P2670?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2670?
Common possibilities to test include: a shorted actuator pulling the supply voltage down; blown fuse or failed relay in the supply circuit; wiring short or open in the supply circuit; engine computer fault (rare). A shop should confirm the cause before replacing parts.