Home › Code lookup › P2672
Powertrain code · Fuel and air

P2672 Injection Pump Timing Offset

How urgent? Get it checked in the next few days

What it means

On a diesel, the fuel injection pump timing is off from where the computer expects it to be.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check whether the pump or timing belt was recently serviced
  2. Compare actual and desired timing in live data

Signs you may notice

  • Check engine light on
  • Hard starting, knocking or smoke
  • Loss of power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonInjection pump timed incorrectly after service
  • CommonWorn timing belt or chain, or slipped timing
  • PossibleFaulty pump timing or position sensor
  • PossibleWorn injection pump

Typical repair once the cause is confirmed

Re-time the injection pump; replace the timing parts or pump if worn.

Walk through it step by step: Hard to start when cold →

Common questions

What does P2672 mean?

On a diesel, the fuel injection pump timing is off from where the computer expects it to be.

Can I drive with code P2672?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2672?

Common possibilities to test include: injection pump timed incorrectly after service; worn timing belt or chain, or slipped timing; faulty pump timing or position sensor; worn injection pump. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.