P2673 Injection Pump Timing Calibration Not Learned
What it means
The diesel injection pump timing has not been calibrated (learned) by the engine computer, often after a part was replaced.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Ask whether the pump or engine computer was recently replaced
- Run the timing relearn with a capable scan tool
Signs you may notice
- Check engine light on
- Rough running or smoke possible
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonCalibration not done after replacing the pump or computer
- CommonRelearn procedure interrupted
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Perform the injection pump timing calibration with a scan tool.
Common questions
What does P2673 mean?
The diesel injection pump timing has not been calibrated (learned) by the engine computer, often after a part was replaced.
Can I drive with code P2673?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2673?
Common possibilities to test include: calibration not done after replacing the pump or computer; relearn procedure interrupted; engine computer fault. A shop should confirm the cause before replacing parts.