Home › Code lookup › P2675
Powertrain code · Fuel and air

P2675 Air Cleaner Inlet Control Circuit/Open

How urgent? Book a check when convenient

What it means

The computer is watching the air cleaner inlet control circuit and sees what looks like a broken or disconnected circuit. Some engines use a flap at the air filter box to switch between cold and warm air or to quiet the intake.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the air cleaner inlet control circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Usually little change in how the car drives

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the air intake flap actuator
  • CommonBroken or chafed wire in the air cleaner inlet control circuit
  • CommonFailed air intake flap actuator
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the air intake flap actuator.

Common questions

What does P2675 mean?

The computer is watching the air cleaner inlet control circuit and sees what looks like a broken or disconnected circuit. Some engines use a flap at the air filter box to switch between cold and warm air or to quiet the intake.

Can I drive with code P2675?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2675?

Common possibilities to test include: unplugged, loose or corroded connector at the air intake flap actuator; broken or chafed wire in the air cleaner inlet control circuit; failed air intake flap actuator; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.