Home › Code lookup › P2676
Powertrain code · Fuel and air

P2676 Air Cleaner Inlet Control Circuit Low

How urgent? Book a check when convenient

What it means

The computer is watching the air cleaner inlet control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Some engines use a flap at the air filter box to switch between cold and warm air or to quiet the intake.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the air cleaner inlet control circuit for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Usually little change in how the car drives

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the air intake flap actuator shorted to ground
  • CommonFailed air intake flap actuator
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the air intake flap actuator.

Common questions

What does P2676 mean?

The computer is watching the air cleaner inlet control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Some engines use a flap at the air filter box to switch between cold and warm air or to quiet the intake.

Can I drive with code P2676?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2676?

Common possibilities to test include: control wire to the air intake flap actuator shorted to ground; failed air intake flap actuator; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.