Home › Code lookup › P2677
Powertrain code · Fuel and air

P2677 Air Cleaner Inlet Control Circuit High

How urgent? Book a check when convenient

What it means

The computer is watching the air cleaner inlet control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Some engines use a flap at the air filter box to switch between cold and warm air or to quiet the intake.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the air cleaner inlet control circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Usually little change in how the car drives

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the air intake flap actuator shorted to voltage or the part open inside
  • CommonFailed air intake flap actuator
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the air intake flap actuator.

Common questions

What does P2677 mean?

The computer is watching the air cleaner inlet control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Some engines use a flap at the air filter box to switch between cold and warm air or to quiet the intake.

Can I drive with code P2677?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2677?

Common possibilities to test include: control wire to the air intake flap actuator shorted to voltage or the part open inside; failed air intake flap actuator; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.