Home › Code lookup › P2680
Powertrain code · Cooling

P2680 Coolant Degassing Valve Control Circuit High

How urgent? Book a check when convenient

What it means

The computer is watching the coolant degassing valve control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This valve helps remove air bubbles from the cooling system.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the coolant degassing valve control circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Possible air pockets or gurgling in the cooling system

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the coolant degassing valve shorted to voltage or the part open inside
  • CommonFailed coolant degassing valve
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the coolant degassing valve.

Common questions

What does P2680 mean?

The computer is watching the coolant degassing valve control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This valve helps remove air bubbles from the cooling system.

Can I drive with code P2680?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2680?

Common possibilities to test include: control wire to the coolant degassing valve shorted to voltage or the part open inside; failed coolant degassing valve; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.