Home › Code lookup › P2687
Powertrain code · Fuel and air

P2687 Fuel Supply Heater Control Circuit/Open

How urgent? Book a check when convenient

What it means

The computer is watching the fuel supply heater control circuit and sees what looks like a broken or disconnected circuit. Diesels warm the fuel in cold weather so it does not thicken or gel.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the fuel supply heater control circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Hard starting or stalling in cold weather

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the fuel heater
  • CommonBroken or chafed wire in the fuel supply heater control circuit
  • CommonFailed fuel heater
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the fuel heater.

Walk through it step by step: Hard to start when cold →

Common questions

What does P2687 mean?

The computer is watching the fuel supply heater control circuit and sees what looks like a broken or disconnected circuit. Diesels warm the fuel in cold weather so it does not thicken or gel.

Can I drive with code P2687?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2687?

Common possibilities to test include: unplugged, loose or corroded connector at the fuel heater; broken or chafed wire in the fuel supply heater control circuit; failed fuel heater; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.