P2689 Fuel Supply Heater Control Circuit High
What it means
The computer is watching the fuel supply heater control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Diesels warm the fuel in cold weather so it does not thicken or gel.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the fuel supply heater control circuit
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- Hard starting or stalling in cold weather
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonControl wire to the fuel heater shorted to voltage or the part open inside
- CommonFailed fuel heater
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the open ground or shorted wire; if the wiring is fine, replace the fuel heater.
Common questions
What does P2689 mean?
The computer is watching the fuel supply heater control circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. Diesels warm the fuel in cold weather so it does not thicken or gel.
Can I drive with code P2689?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2689?
Common possibilities to test include: control wire to the fuel heater shorted to voltage or the part open inside; failed fuel heater; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.