P2692 Cylinder 7 Injector Data Incompatible
What it means
The engine computer has correction values for the cylinder 7 fuel injector that do not match what it expects. This usually happens after an injector or the computer is replaced and not coded correctly.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Read the code printed on each injector and compare it with what is stored in the computer
- Ask whether injectors or the engine computer were recently replaced
Signs you may notice
- Check engine light on
- Rough idle or knocking from uneven fueling
- Possible smoke or reduced power
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonNew injector installed without entering its code into the computer
- CommonWrong injector code entered
- PossibleEngine computer replaced or reprogrammed without injector data
- PossibleIncorrect injector part number
Typical repair once the cause is confirmed
Program the correct injector codes into the engine computer with a capable scan tool.
Common questions
What does P2692 mean?
The engine computer has correction values for the cylinder 7 fuel injector that do not match what it expects. This usually happens after an injector or the computer is replaced and not coded correctly.
Can I drive with code P2692?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2692?
Common possibilities to test include: new injector installed without entering its code into the computer; wrong injector code entered; engine computer replaced or reprogrammed without injector data; incorrect injector part number. A shop should confirm the cause before replacing parts.