Home › Code lookup › P2697
Powertrain code · Emissions

P2697 Exhaust Aftertreatment Fuel Injector "A" Circuit/Open

How urgent? Get it checked in the next few days

What it means

The computer is watching the exhaust aftertreatment fuel injector and sees what looks like a broken or disconnected circuit. Some diesels spray a little fuel into the exhaust to heat and clean the particulate filter.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the exhaust aftertreatment fuel injector, checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Particulate filter cleaning may not happen
  • Reduced power if the filter clogs

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the exhaust fuel injector (doser)
  • CommonBroken or chafed wire in the exhaust aftertreatment fuel injector circuit
  • CommonFailed exhaust fuel injector (doser)
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the exhaust fuel injector (doser).

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2697 mean?

The computer is watching the exhaust aftertreatment fuel injector and sees what looks like a broken or disconnected circuit. Some diesels spray a little fuel into the exhaust to heat and clean the particulate filter.

Can I drive with code P2697?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2697?

Common possibilities to test include: unplugged, loose or corroded connector at the exhaust fuel injector (doser); broken or chafed wire in the exhaust aftertreatment fuel injector circuit; failed exhaust fuel injector (doser); blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.