Home › Code lookup › P2698
Powertrain code · Emissions

P2698 Exhaust Aftertreatment Fuel Injector "A" Performance

How urgent? Get it checked in the next few days

What it means

The exhaust aftertreatment fuel injector is not responding the way the computer expects. Some diesels spray a little fuel into the exhaust to heat and clean the particulate filter.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other codes that point to the underlying problem
  2. Compare the exhaust aftertreatment fuel injector reading with expected values in live data
  3. Inspect the wiring and connector

Signs you may notice

  • Check engine light on
  • Particulate filter cleaning may not happen
  • Reduced power if the filter clogs

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonClogged or carbon-fouled exhaust fuel injector
  • CommonLow fuel supply pressure to the injector
  • PossibleLeaking injector or fuel line
  • PossibleWiring fault

Typical repair once the cause is confirmed

Clean or replace the exhaust fuel injector and check its fuel supply.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2698 mean?

The exhaust aftertreatment fuel injector is not responding the way the computer expects. Some diesels spray a little fuel into the exhaust to heat and clean the particulate filter.

Can I drive with code P2698?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2698?

Common possibilities to test include: clogged or carbon-fouled exhaust fuel injector; low fuel supply pressure to the injector; leaking injector or fuel line; wiring fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.