Home › Code lookup › P2699
Powertrain code · Emissions

P2699 Exhaust Aftertreatment Fuel Injector "A" Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer is watching the exhaust aftertreatment fuel injector and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Some diesels spray a little fuel into the exhaust to heat and clean the particulate filter.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the exhaust aftertreatment fuel injector for rubbed-through insulation touching metal
  2. Check the wiring for a short to ground with a meter
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Particulate filter cleaning may not happen
  • Reduced power if the filter clogs

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire to the exhaust fuel injector (doser) shorted to ground
  • CommonFailed exhaust fuel injector (doser)
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the exhaust fuel injector (doser).

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2699 mean?

The computer is watching the exhaust aftertreatment fuel injector and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Some diesels spray a little fuel into the exhaust to heat and clean the particulate filter.

Can I drive with code P2699?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2699?

Common possibilities to test include: control wire to the exhaust fuel injector (doser) shorted to ground; failed exhaust fuel injector (doser); corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.