Your 1997 Dodge Dakotaproblems, repair costs and recalls
What we've documented about the 1997 Dodge Dakota: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1997 Dodge Dakota
8 documented issues apply to 1997, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- Slipping when accelerating hard or going uphill, late or harsh shifts, the transmission stuck in one gear (limp mode), no reverse, or the truck not moving in gear.
- Why it happens
- The automatics in the Dakota wear out from heat, especially when towing or hauling, and the torque converter can fail. Old fluid speeds up the wear.
- What to do
- Check the fluid level and smell right away. If it slips or goes into limp mode, have codes read and get a transmission diagnosis before driving much more.
Front ball joints wear out early
- What you'll notice
- Clunking from the front end, loose or wandering steering, uneven tire wear, or a wobble at speed.
- Why it happens
- The factory upper and lower ball joints are sealed and wear out quickly once their boots tear and water gets in, often well before 100,000 miles. A separated joint can let a wheel fold under.
- What to do
- Have the front end checked if you hear clunks. Replace worn joints in pairs and get an alignment afterwards.
Clockspring can disable driver airbag (recall)
- What you'll notice
- The airbag warning light comes on, and the horn or steering wheel controls may stop working.
- Why it happens
- Material inside the steering column clockspring can cut the ribbon wire that carries the airbag signal, so the driver airbag would not deploy. Recall 01V-153.
- What to do
- If the airbag light is on, have the codes read and check your VIN for the recall.
Free under recall 01V-153. Outside the recall, a clockspring is a paid part plus labor; ask for a written quote.
Brake tube or hose can be rubbed through (recall)
- What you'll notice
- A soft or low brake pedal, the brake warning light, or brake fluid leaking near a front wheel or the rear axle.
- Why it happens
- The left front brake tube can be worn through by a steering hose, and the rear brake hose can be punctured by the rear axle vent hose. Recalls 00V-193 and 00V-198.
- What to do
- If the pedal goes soft or fluid is leaking, do not drive the truck. Check the VIN for these recalls.
Free under the recall. Ask a dealer to check your VIN for open recalls.
Intake plenum gasket leak burns oil
- What you'll notice
- The engine uses oil with no outside leak, pings under acceleration, idles rough or misfires, and oil can be seen inside the throttle body. Spark plugs and oxygen sensors foul.
- Why it happens
- The gasket under the stamped-steel plate on the bottom of the Magnum intake manifold fails, so oil vapor from the crankcase is pulled into the engine and burned. Chrysler issued a service bulletin (09-05-00) for it.
- What to do
- Have a shop check for oil in the intake and test for the leak. Fix it with an upgraded plate-and-gasket kit rather than just a new paper gasket, so it does not come back.
Camshaft position sensor failure
- What you'll notice
- Check engine light with codes like P0340 or P1391, hard starting or no start, rough idle, misfires or stalling.
- Why it happens
- The camshaft position sensor in the distributor gets dirty or fails with age, and the engine computer loses track of timing.
- What to do
- Have the codes read. The sensor is inexpensive and quick to replace; do not keep driving if the engine stalls in traffic.
Stalling while driving from crank sensor fault
- What you'll notice
- The engine cuts out while driving or coasting to a stop, idles rough, or cranks but will not start until it sits for a while.
- Why it happens
- On these trucks the crankshaft position sensor or its wiring connection fails, so the engine computer loses the signal it needs to run the engine. Owners also report a loose engine computer connector causing the same thing.
- What to do
- Have codes read right after a stall. A shop can check the crank sensor signal and its connector; replacing the sensor is a common first fix.
Broken exhaust manifold bolts cause ticking
- What you'll notice
- A ticking or puffing noise from the engine bay that is loudest on a cold start and may fade as the engine warms up. Sometimes an exhaust smell.
- Why it happens
- The bolts holding the exhaust manifolds to the cylinder heads rust and snap from repeated heating and cooling, letting exhaust leak at the joint.
- What to do
- Not urgent, but have it fixed before more bolts break or the gasket burns through. Keep exhaust fumes out of the cab.
Repair prices for your 1997 Dodge Dakota
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace intake plenum pan gasket with upgraded plate kit
- Replace camshaft position sensor
- Extract broken manifold bolts and replace bolts and gasket
- Replace crankshaft position sensor
- Replace automatic transmission with remanufactured unit
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a Dodge/Ram dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…