Your 2010 Dodge Dakotaproblems, repair costs and recalls
What we've documented about the 2010 Dodge Dakota: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Dodge Dakota
12 documented issues apply to 2010, most serious first.
Dropped valve seat causing misfire and lost power
- What you'll notice
- A steady misfire on one cylinder, a flashing or steady check engine light, rough running and lower power. Sometimes the engine suddenly starts ticking or knocking.
- Why it happens
- On these engines a valve seat pressed into the cylinder head can loosen and drop out, usually after the engine has run hot. The valve then cannot seal, and loose pieces can damage the piston.
- What to do
- If a misfire stays on one cylinder after new plugs and coils, ask for a compression or leak-down test. Stop driving if there is a new knocking sound. Fixing it means a rebuilt or new cylinder head.
Overheating and head gasket failure
- What you'll notice
- The temperature gauge climbs, coolant keeps going down with no visible leak, white sweet-smelling exhaust smoke, or milky oil.
- Why it happens
- The 4.7L is sensitive to heat. A tired water pump, thermostat, fan clutch or radiator lets it run hot, and overheating then damages the head gaskets and valve seats.
- What to do
- Stop driving as soon as the gauge rises. Have the cooling system pressure tested and a combustion-gas test done. Fixing the cooling part early is far cheaper than a head gasket job.
Automatic transmission slipping or failing
- What you'll notice
- Slipping when accelerating hard or going uphill, late or harsh shifts, the transmission stuck in one gear (limp mode), no reverse, or the truck not moving in gear.
- Why it happens
- The automatics in the Dakota wear out from heat, especially when towing or hauling, and the torque converter can fail. Old fluid speeds up the wear.
- What to do
- Check the fluid level and smell right away. If it slips or goes into limp mode, have codes read and get a transmission diagnosis before driving much more.
Lower ball joints, tie rods and sway bar links wear
- What you'll notice
- Clunking or knocking over bumps, steering that feels loose, a pull to one side, or uneven tire wear. Some owners had a lower ball joint break.
- Why it happens
- The front lower ball joints, outer tie rod ends and sway bar end links on this generation wear out, and owners report replacing them from about 35,000 miles on.
- What to do
- Have the front end inspected at the first clunk. A broken ball joint can make you lose control, so do not put it off.
Takata airbag inflators can rupture (recall)
- What you'll notice
- No warning signs. The danger is that in a crash the driver or passenger front airbag inflator can burst and throw metal pieces into the cab.
- Why it happens
- Airbag inflators made by Takata use a propellant that breaks down after years of heat and humidity. Recalls 15V-313 (driver) and 16V-352, 18V-021 and 19V-018 (passenger) cover these Dakotas.
- What to do
- Ask the dealer to check your VIN today and get the free replacement as soon as possible.
Free under the recall. Ask a dealer to check your VIN for open recalls.
Rear axle pinion nut can loosen and lock the axle (recall)
- What you'll notice
- Clunking or noise from the rear axle. In the worst case the rear wheels lock up while driving.
- Why it happens
- The nut that holds the drive pinion in the rear differential can work loose because not enough thread adhesive was used. Recalls 12V-474 and 13V-038 add a retainer.
- What to do
- Check your VIN for open recalls and have the free fix done. Get any new rear-axle noise checked promptly.
Free under the recall. Ask a dealer to check your VIN for open recalls.
Radiator leaks and overheating
- What you'll notice
- Coolant on the ground at the front of the truck, low coolant, the temperature gauge rising, or steam from the radiator.
- Why it happens
- The radiators on these trucks crack and leak with age. The transmission cooler lines at the radiator can also start to leak.
- What to do
- Keep an eye on the temperature gauge and do not drive if it runs hot. Have the radiator and cooler lines pressure tested and replace the radiator if it is leaking.
Steering wheel shake when braking from warped rotors
- What you'll notice
- The steering wheel or truck shakes when braking from highway speed, sometimes with a pulsing pedal or a dragging, hot front wheel.
- Why it happens
- The front rotors warp from heat, often because a front caliper does not fully release.
- What to do
- Have the brakes inspected. Replace rotors and pads, and the caliper if it is sticking.
Rust on radiator support and body panels
- What you'll notice
- Bubbling paint on the rear fenders or doors, rust around the wheel wells, and rot on the radiator support under the hood, sometimes hidden by trim.
- Why it happens
- Road salt and trapped moisture rust the radiator support area and lower body panels on these trucks.
- What to do
- Inspect under the hood and around the fenders each year, especially in snowy states. Treat rust early; a rotted radiator support should be repaired by a body shop.
Broken exhaust manifold bolts cause ticking
- What you'll notice
- A ticking or puffing noise from the engine bay that is loudest on a cold start and may fade as the engine warms up. Sometimes an exhaust smell.
- Why it happens
- The bolts holding the exhaust manifolds to the cylinder heads rust and snap from repeated heating and cooling, letting exhaust leak at the joint.
- What to do
- Not urgent, but have it fixed before more bolts break or the gasket burns through. Keep exhaust fumes out of the cab.
Transfer case output seal leak (4x4)
- What you'll notice
- Red fluid dripping from the middle of the truck, a burning smell, grinding when shifting into 4WD, or a whine at highway speed.
- Why it happens
- The rubber seals where the driveshafts leave the transfer case dry out and crack with heat and age.
- What to do
- Check the transfer case fluid level and have the leaking seal replaced before the case runs low and gets damaged.
Clicking behind dash and wrong air temperature
- What you'll notice
- A repeated clicking or ticking from behind the dashboard, or air that stays hot or cold no matter where the knob is set.
- Why it happens
- A plastic blend door actuator motor inside the heater box strips its gears or fails.
- What to do
- Not a safety problem. Have the actuator replaced; on many trucks it can be reached from under the dash.
Repair prices for your 2010 Dodge Dakota
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace or rebuild one cylinder head with new gaskets
- Replace head gaskets (one or both sides)
- Extract broken manifold bolts and replace bolts and gasket
- Replace radiator and refill coolant
- Replace automatic transmission with remanufactured unit
- Replace front lower ball joints and align
- Replace front brake pads and rotors
- Replace HVAC blend door actuator
- Repair or replace rusted radiator support section
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a Dodge/Ram dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…