Your 2016 Mazda Mazda3problems, repair costs and recalls
What we've documented about the 2016 Mazda Mazda3: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2016 Mazda Mazda3
8 documented issues apply to 2016, most serious first.
Parking brake can rust and stick (recall)
- What you'll notice
- The parking brake does not fully release, the rear brakes drag or get hot, or the parking brake does not hold well.
- Why it happens
- Water can get into the rear calipers and corrode the parking brake actuator shaft so it binds. Mazda recalled these cars to inspect and replace corroded shafts.
- What to do
- Check your VIN for an open recall. Have the rear brakes checked right away if they drag or the parking brake will not hold.
Fuel tank weld can leak (recall)
- What you'll notice
- A fuel smell around the rear of the car or drips under the fuel tank.
- Why it happens
- Some fuel tanks were damaged or poorly welded at the factory, and a weld near the fill check valve can fail and leak. Mazda recalled affected cars to inspect and replace tanks.
- What to do
- Check your VIN for an open recall. If you smell fuel or see a leak, do not drive the car; have it inspected because leaking fuel is a fire risk.
Fuel shut-off valve can cause leak or stall (recall)
- What you'll notice
- A fuel smell, a check engine light, rough running, or the engine stalling after a fill-up.
- Why it happens
- A faulty shut-off valve in the fuel tank can let liquid fuel into the evaporative emissions system, which can lead to a fuel leak or a stall. Owners were told not to drive until it was repaired.
- What to do
- Check your VIN for an open recall and do not drive the car until the recall repair is done.
Windshield wipers can stop working (recall)
- What you'll notice
- The wipers work on and off or stop entirely.
- Why it happens
- A faulty wiper relay inside the front body control module can fail. Mazda recalled these cars to replace the module.
- What to do
- Check your VIN for an open recall. Do not drive in rain or snow if the wipers act up; get the repair done first.
Oil leak and rattle from the drive belt tensioner
- What you'll notice
- A rattle from the front of the engine, mostly when accelerating, and oily residue around the belt tensioner.
- Why it happens
- The hydraulic auto-tensioner for the drive belt on the 2.0L Skyactiv engine can leak its oil and lose damping, letting the belt flap. Mazda issued a bulletin covering the leak and noise.
- What to do
- Have the tensioner and belt inspected. Replace a leaking tensioner before the belt slips or comes off, which would cut charging and engine cooling.
No-start, battery drain or odd electrical faults linked to accessories
- What you'll notice
- The car intermittently will not start, the security light flashes, the battery runs down overnight, or the backup camera picture blurs.
- Why it happens
- Mazda found that plug-in chargers, dash cams, GPS units and other aftermarket devices can upset the electrical system on these cars, and issued bulletins telling technicians to check for them first.
- What to do
- Unplug all aftermarket devices and see if the problem stops. If it continues, have the battery, charging system and wiring connections tested.
Backup camera picture flickers or distorts (recall)
- What you'll notice
- The rearview camera image flickers, is distorted, or does not show when you shift into reverse.
- Why it happens
- Moisture can get into the camera and its connector. Mazda recalled these cars to replace the camera and seal the harness.
- What to do
- Check your VIN for an open recall. Until it is fixed, check around the car with mirrors and over your shoulder before backing up.
Mazda Connect screen ghost touches, freezes or reboots
- What you'll notice
- The touchscreen selects things on its own, freezes, keeps rebooting, goes blank, drops Bluetooth or navigation, or the backup camera picture does not appear.
- Why it happens
- The early Mazda Connect system can register false touches and its software can get stuck in a reboot loop. Mazda issued several service bulletins, and a class action settlement extended coverage on these units.
- What to do
- Ask a dealer to update the software and check whether the settlement warranty extension applies to your car. Unplug aftermarket accessories to rule them out. A screen that keeps acting on its own usually needs replacement.
Repair prices for your 2016 Mazda Mazda3
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace drive belt tensioner and belt
- Replace Mazda Connect touchscreen display
- Diagnose drain and remove or rewire the accessory
- Replace rear caliper with parking brake mechanism
- Replace fuel tank
- Replace fuel tank shut-off valve
- Replace rear camera or camera harness
- Replace windshield wiper motor
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…