Your 2017 Ram 2500problems, repair costs and recalls
What we've documented about the 2017 Ram 2500: problems owners and shops report, typical repair and upkeep costs, and safety recalls. Sold as the Dodge Ram 2500 through the 2010 model year.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2017 Ram 2500
5 documented issues apply to 2017, most serious first.
Violent front-end shake ("death wobble") from worn front-end parts
- What you'll notice
- Hard side-to-side shaking of the steering wheel and front end after hitting a bump at speed, or loose, wandering steering.
- Why it happens
- The solid front axle relies on the track bar, tie rods, drag link, ball joints and steering damper. Wear or looseness in any of them, and quick-wearing ball joints on early trucks, can start the shake.
- What to do
- Slow down gently and pull over when it happens. Have the whole front end inspected for play before driving far, and check the VIN for open steering recalls.
Intake heater grid bolt can loosen and fall into the engine
- What you'll notice
- Often no warning before it fails. Sometimes hard cold starts. If the bolt drops in, sudden knocking and severe engine damage.
- Why it happens
- The grid heater that warms intake air for cold starts is held by internal fasteners that loosen from heat, soot and corrosion over many miles.
- What to do
- Ask a diesel shop to check the grid heater for looseness at service time on higher-mileage trucks. Stop the engine at once if a sudden knock appears.
Drag link nut can loosen (recall 19V-021)
- What you'll notice
- Loose or wandering steering, clunking, or a sudden loss of steering if the link separates.
- Why it happens
- A jam nut on the steering drag link adjuster may not hold, letting one end of the link separate.
- What to do
- Check the VIN for this recall and have it done right away. Have any new steering looseness inspected before driving.
Hemi lifter and camshaft wear
- What you'll notice
- A steady ticking or tapping from the engine, then misfires, a rough idle and a check-engine light.
- Why it happens
- Roller lifters can stop rolling and wear flat, then grind down the camshaft lobes. It is widely reported and the subject of a class action lawsuit.
- What to do
- Have a ticking Hemi checked promptly; catching it early limits the damage. Use the correct oil and change it on time.
DEF / SCR system faults and NOx sensor failures
- What you'll notice
- Emissions warnings, a countdown to reduced speed, erratic DEF gauge readings, white crystals around the dosing parts, or heater faults in winter.
- Why it happens
- The exhaust fluid system can be upset by contaminated or old fluid, crystal buildup in the pump or doser, and failing heaters or NOx sensors.
- What to do
- Use fresh, sealed DEF and have warnings checked before the speed limit kicks in.
Repair prices for your 2017 Ram 2500
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace NOx sensor
- Inspect and secure drag link nut; replace drag link if needed
- Replace camshaft and lifters
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…