Your 2020 Ram 2500problems, repair costs and recalls
What we've documented about the 2020 Ram 2500: problems owners and shops report, typical repair and upkeep costs, and safety recalls. Sold as the Dodge Ram 2500 through the 2010 model year.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2020 Ram 2500
5 documented issues apply to 2020, most serious first.
Hemi lifter and camshaft wear
- What you'll notice
- A steady ticking or tapping from the engine, then misfires, a rough idle and a check-engine light.
- Why it happens
- Roller lifters can stop rolling and wear flat, then grind down the camshaft lobes. It is widely reported and the subject of a class action lawsuit.
- What to do
- Have a ticking Hemi checked promptly; catching it early limits the damage. Use the correct oil and change it on time.
CP4 high-pressure fuel pump failure
- What you'll notice
- Hard starting, loss of power or the engine shutting off while driving, sometimes with low fuel pressure codes.
- Why it happens
- The CP4 pump used for these two years can wear internally and send metal through the whole fuel system. Ram went back to the older CP3 pump for 2021.
- What to do
- Drain the water separator and change fuel filters on time. Tow the truck in if it stalls; metal in the filter means the whole fuel system needs inspection.
Transmission fluid can spray from the dipstick tube (recall 22V-835)
- What you'll notice
- A hot oil smell or smoke from under the truck after hard driving or towing, and wet fluid near the dipstick tube.
- Why it happens
- On the 68RFE six-speed automatic, heat and pressure can push fluid out of the dipstick tube onto hot parts, creating a fire risk and lowering the fluid level.
- What to do
- Check the VIN for this recall and have the fluid level checked. Pull over and shut off the engine if you see smoke.
DEF / SCR system faults and NOx sensor failures
- What you'll notice
- Emissions warnings, a countdown to reduced speed, erratic DEF gauge readings, white crystals around the dosing parts, or heater faults in winter.
- Why it happens
- The exhaust fluid system can be upset by contaminated or old fluid, crystal buildup in the pump or doser, and failing heaters or NOx sensors.
- What to do
- Use fresh, sealed DEF and have warnings checked before the speed limit kicks in.
Wheel speed sensor faults (TSB 05-004-24)
- What you'll notice
- ABS, traction control or brake warning lights coming on, sometimes on and off.
- Why it happens
- Wheel speed sensor faults are a known issue on these trucks, and Ram issued a service bulletin for them.
- What to do
- Have the codes read and ask the dealer about TSB 05-004-24. ABS and stability control may not work while the light is on.
Repair prices for your 2020 Ram 2500
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace NOx sensor
- Replace camshaft and lifters
- Replace CP4 pump, injectors, rail and lines; clean fuel system
- Replace transmission dipstick and vent assembly per recall
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…