Home › Code lookup › P0411
Powertrain code · Emissions

P0411 Secondary Air Injection System Incorrect Flow Detected

How urgent? Book a check when convenient

What it means

The system that blows fresh air into the exhaust during cold starts is not moving the amount of air the computer expects.

Can I keep driving?

Usually you can keep driving; this system mainly cuts emissions for the first minute or so after a cold start. Get it repaired before an emissions test. If you notice a burning smell near the pump or the fuse keeps blowing, get it checked sooner.

What to test before replacing parts

Check pump output on a cold start, test the check and switching valves, look for blocked passages and leaking hoses, and confirm the oxygen sensor responds correctly before replacing parts.

  1. Run the air pump with a scan tool and watch upstream O2 sensor readings go lean
  2. Check hoses and the check valve for leaks or blockage
  3. Check the pump fuse and relay

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • Air pump may sound unusually loud or quiet on cold start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWeak or failed secondary air pump
  • CommonStuck check or switching valve
  • CommonClogged or carbon-blocked air passages
  • PossibleLeaking air hoses
  • PossibleFaulty upstream oxygen sensor reading the wrong result

Typical repair once the cause is confirmed

Usually replacing the air pump or the switching/check valve, or clearing blocked passages.

Repair costInsufficient verified pricing for this vehicle and repair
Replace secondary air injection pump. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P0411 mean?

The system that blows fresh air into the exhaust during cold starts is not moving the amount of air the computer expects.

Can I drive with code P0411?

Usually you can keep driving; this system mainly cuts emissions for the first minute or so after a cold start. Get it repaired before an emissions test. If you notice a burning smell near the pump or the fuse keeps blowing, get it checked sooner.

What causes P0411?

Common possibilities to test include: weak or failed secondary air pump; stuck check or switching valve; clogged or carbon-blocked air passages; leaking air hoses. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.